| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the access control list (ACL) processing on Pseudowire interfaces in the ingress direction of Cisco IOS XR Software could allow an unauthenticated, remote attacker to bypass a configured ACL.
This vulnerability is due to improper assignment of lookup keys to internal interface contexts. An attacker could exploit this vulnerability by attempting to send traffic through an affected device. A successful exploit could allow the attacker to access resources behind the affected device that were supposed to be protected by a configured ACL. |
| A vulnerability in the SSH client feature of Cisco IOS XR Software for Cisco 8000 Series Routers and Cisco Network Convergence System (NCS) 540 Series and 5700 Series Routers could allow an authenticated, local attacker to elevate privileges on an affected device.
This vulnerability is due to insufficient validation of arguments that are included with the SSH client CLI command. An attacker with low-privileged access to an affected device could exploit this vulnerability by issuing a crafted SSH client command to the CLI. A successful exploit could allow the attacker to elevate privileges to root on the affected device. |
| A vulnerability in the Network Configuration Access Control Module (NACM) of Cisco IOS XE Software could allow an authenticated, remote attacker to obtain unauthorized read access to configuration or operational data.
This vulnerability exists because a subtle change in inner API call behavior causes results to be filtered incorrectly. An attacker could exploit this vulnerability by using either NETCONF, RESTCONF, or gRPC Network Management Interface (gNMI) protocols and query data on paths that may have been denied by the NACM configuration. A successful exploit could allow the attacker to access data that should have been restricted according to the NACM configuration.
Note: This vulnerability requires that the attacker obtain the credentials from a valid user with privileges lower than 15, and that NACM was configured to provide restricted read access for that user. |
| A vulnerability in the Cisco Express Forwarding functionality of Cisco IOS XE Software for Cisco ASR 903 Aggregation Services Routers with Route Switch Processor 3 (RSP3C) could allow an unauthenticated, adjacent attacker to trigger a denial of service (DoS) condition.
This vulnerability is due to improper memory management when Cisco IOS XE Software is processing Address Resolution Protocol (ARP) messages. An attacker could exploit this vulnerability by sending crafted ARP messages at a high rate over a period of time to an affected device. A successful exploit could allow the attacker to exhaust system resources, which eventually triggers a reload of the active route switch processor (RSP). If a redundant RSP is not present, the router reloads. |
| A vulnerability in the implementation of the Simple Network Management Protocol Version 3 (SNMPv3) feature of Cisco IOS Software and Cisco IOS XE Software could allow an authenticated, remote attacker to poll an affected device using SNMP, even if the device is configured to deny SNMP traffic from an unauthorized source or the SNMPv3 username is removed from the configuration.
This vulnerability exists because of the way that the SNMPv3 configuration is stored in the Cisco IOS Software and Cisco IOS XE Software startup configuration. An attacker could exploit this vulnerability by polling an affected device from a source address that should have been denied. A successful exploit could allow the attacker to perform SNMP operations from a source that should be denied.
Note: The attacker has no control of the SNMPv3 configuration. To exploit this vulnerability, the attacker must have valid SNMPv3 user credentials.
For more information, see the section of this advisory. |
| A vulnerability in the access control list (ACL) programming of Cisco IOS Software that is running on Cisco Catalyst 1000 Switches and Cisco Catalyst 2960L Switches could allow an unauthenticated, remote attacker to bypass a configured ACL.
This vulnerability is due to the use of both an IPv4 ACL and a dynamic ACL of IP Source Guard on the same interface, which is an unsupported configuration. An attacker could exploit this vulnerability by attempting to send traffic through an affected device. A successful exploit could allow the attacker to bypass an ACL on the affected device.
Note: Cisco documentation has been updated to reflect that this is an unsupported configuration. However, Cisco is publishing this advisory because the device will not prevent an administrator from configuring both features on the same interface. There are no plans to implement the ability to configure both features on the same interface on Cisco Catalyst 1000 or Catalyst 2960L Switches. |
| A vulnerability in the Cisco Discovery Protocol implementation for Cisco IOS XR Software could allow an unauthenticated, adjacent attacker to cause the Cisco Discovery Protocol process to reload on an affected device.
This vulnerability is due to a heap buffer overflow in certain Cisco Discovery Protocol messages. An attacker could exploit this vulnerability by sending a malicious Cisco Discovery Protocol packet to an affected device. A successful exploit could allow the attacker to cause a heap overflow, which could cause the Cisco Discovery Protocol process to reload on the device. The bytes that can be written in the buffer overflow are restricted, which limits remote code execution.Note: Cisco Discovery Protocol is a Layer 2 protocol. To exploit this vulnerability, an attacker must be in the same broadcast domain as the affected device (Layer 2 adjacent). Cisco has released software updates that address this vulnerability. There are no workarounds that address this vulnerability.This advisory is part of the September 2022 release of the Cisco IOS XR Software Security Advisory Bundled Publication. For a complete list of the advisories and links to them, see . |
| A vulnerability in Cisco IOS Software for Cisco Catalyst 2960X, 2960XR, 2960CX, and 3560CX Series Switches could allow an authenticated, local attacker with privilege level 15 or an unauthenticated attacker with physical access to the device to execute persistent code at boot time and break the chain of trust.
This vulnerability is due to missing signature verification for specific files that may be loaded during the device boot process. An attacker could exploit this vulnerability by placing a crafted file into a specific location on an affected device. A successful exploit could allow the attacker to execute arbitrary code at boot time.
Because this allows the attacker to bypass a major security feature of the device, Cisco has raised the Security Impact Rating (SIR) of this advisory from Medium to High. |
| A vulnerability in the boot process of Cisco IOS XR Software could allow an authenticated, local attacker with high privileges to bypass the Cisco Secure Boot functionality and load unverified software on an affected device. To exploit this successfully, the attacker must have root-system privileges on the affected device.
This vulnerability is due to an error in the software build process. An attacker could exploit this vulnerability by manipulating the system’s configuration options to bypass some of the integrity checks that are performed during the booting process. A successful exploit could allow the attacker to control the boot configuration, which could enable them to bypass of the requirement to run Cisco signed images or alter the security properties of the running system. |
| A vulnerability in the access control list (ACL) processing in the egress direction of Cisco IOS XR Software could allow an unauthenticated, remote attacker to bypass a configured ACL.
This vulnerability exists because certain packets are handled incorrectly when they are received on an ingress interface on one line card and destined out of an egress interface on another line card where the egress ACL is configured. An attacker could exploit this vulnerability by attempting to send traffic through an affected device. A successful exploit could allow the attacker to bypass an egress ACL on the affected device.
For more information about this vulnerability, see the section of this advisory.
Cisco has released software updates that address this vulnerability. There are no workarounds that address this vulnerability. |
| A vulnerability in the hybrid access control list (ACL) processing of IPv4 packets in Cisco IOS XR Software could allow an unauthenticated, remote attacker to bypass a configured ACL.
This vulnerability is due to incorrect handling of packets when a specific configuration of the hybrid ACL exists. An attacker could exploit this vulnerability by attempting to send traffic through an affected device. A successful exploit could allow the attacker to bypass a configured ACL on the affected device.
For more information, see the section of this advisory.
Cisco has released software updates that address this vulnerability. There are workarounds that address this vulnerability. |
| A vulnerability in the Layer 3 multicast feature of Cisco IOS XR Software for Cisco ASR 9000 Series Aggregation Services Routers, ASR 9902 Compact High-Performance Routers, and ASR 9903 Compact High-Performance Routers could allow an unauthenticated, remote attacker to cause a line card to reset, resulting in a denial of service (DoS) condition.
This vulnerability is due to the incorrect handling of malformed IPv4 multicast packets that are received on line cards where the interface has either an IPv4 access control list (ACL) or a QoS policy applied. An attacker could exploit this vulnerability by sending crafted IPv4 multicast packets through an affected device. A successful exploit could allow the attacker to cause line card exceptions or a hard reset. Traffic over that line card would be lost while the line card reloads. |
| A vulnerability in the IPv4 access control list (ACL) feature and quality of service (QoS) policy feature of Cisco IOS XR Software for Cisco ASR 9000 Series Aggregation Services Routers, ASR 9902 Compact High-Performance Routers, and ASR 9903 Compact High-Performance Routers could allow an unauthenticated, remote attacker to cause a line card to reset, resulting in a denial of service (DoS) condition.
This vulnerability is due to the incorrect handling of malformed IPv4 packets that are received on line cards where the interface has either an IPv4 ACL or QoS policy applied. An attacker could exploit this vulnerability by sending crafted IPv4 packets through an affected device. A successful exploit could allow the attacker to cause network processor errors, resulting in a reset or shutdown of the network process. Traffic over that line card would be lost while the line card reloads.
Note: This vulnerability has predominantly been observed in Layer 2 VPN (L2VPN) environments where an IPv4 ACL or QoS policy has been applied to the bridge virtual interface. Layer 3 configurations where the interface has either an IPv4 ACL or QoS policy applied are also affected, though the vulnerability has not been observed. |
| A vulnerability in the implementation of the Resource Public Key Infrastructure (RPKI) feature of Cisco IOS XR Software could allow an unauthenticated, remote attacker to cause the Border Gateway Protocol (BGP) process to crash, resulting in a denial of service (DoS) condition.
This vulnerability is due to the incorrect handling of a specific RPKI to Router (RTR) Protocol packet header. An attacker could exploit this vulnerability by compromising the RPKI validator server and sending a specifically crafted RTR packet to an affected device. Alternatively, the attacker could use man-in-the-middle techniques to impersonate the RPKI validator server and send a specifically crafted RTR response packet over the established RTR TCP connection to the affected device. A successful exploit could allow the attacker to cause a DoS condition because the BGP process could constantly restart and BGP routing could become unstable.Cisco has released software updates that address this vulnerability. There are no workarounds that address this vulnerability.This advisory is part of the September 2021 release of the Cisco IOS XR Software Security Advisory Bundled Publication. For a complete list of the advisories and links to them, see . |
| A vulnerability in the Broadband Network Gateway PPP over Ethernet (PPPoE) feature of Cisco IOS XR Software could allow an unauthenticated, adjacent attacker to cause the PPPoE process to continually crash.
This vulnerability exists because the PPPoE feature does not properly handle an error condition within a specific crafted packet sequence. An attacker could exploit this vulnerability by sending a sequence of specific PPPoE packets from controlled customer premises equipment (CPE). A successful exploit could allow the attacker to cause the PPPoE process to continually restart, resulting in a denial of service condition (DoS).Cisco has released software updates that address this vulnerability. There are no workarounds that address this vulnerability.This advisory is part of the September 2022 release of the Cisco IOS XR Software Security Advisory Bundled Publication. For a complete list of the advisories and links to them, see . |
| A vulnerability in the implementation of the Simple Network Management Protocol (SNMP) IPv4 access control list (ACL) feature of Cisco IOS Software and Cisco IOS XE Software could allow an unauthenticated, remote attacker to perform SNMP polling of an affected device, even if it is configured to deny SNMP traffic.
This vulnerability exists because Cisco IOS Software and Cisco IOS XE Software do not support extended IPv4 ACLs for SNMP, but they do allow administrators to configure extended named IPv4 ACLs that are attached to the SNMP server configuration without a warning message. This can result in no ACL being applied to the SNMP listening process. An attacker could exploit this vulnerability by performing SNMP polling of an affected device. A successful exploit could allow the attacker to perform SNMP operations that should be denied. The attacker has no control of the SNMP ACL configuration and would still need a valid SNMP version 2c (SNMPv2c) community string or SNMP version 3 (SNMPv3) user credentials.
SNMP with IPv6 ACL configurations is not affected.
For more information, see the section of this advisory. |
| A vulnerability in confederation implementation for the Border Gateway Protocol (BGP) in Cisco IOS XR Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition.
This vulnerability is due to a memory corruption that occurs when a BGP update is created with an AS_CONFED_SEQUENCE attribute that has 255 autonomous system numbers (AS numbers). An attacker could exploit this vulnerability by sending a crafted BGP update message, or the network could be designed in such a manner that the AS_CONFED_SEQUENCE attribute grows to 255 AS numbers or more. A successful exploit could allow the attacker to cause memory corruption, which may cause the BGP process to restart, resulting in a DoS condition. To exploit this vulnerability, an attacker must control a BGP confederation speaker within the same autonomous system as the victim, or the network must be designed in such a manner that the AS_CONFED_SEQUENCE attribute grows to 255 AS numbers or more. |
| A vulnerability in the NETCONF feature of Cisco IOS XE Software could allow an authenticated, remote attacker to elevate privileges to root on an affected device.
This vulnerability is due to improper validation of user-supplied input. An attacker could exploit this vulnerability by sending crafted input over NETCONF to an affected device. A successful exploit could allow the attacker to elevate privileges from Administrator to root. |
| A vulnerability in the SSH implementation of Cisco IOS Software and Cisco IOS XE Software could allow an authenticated, remote attacker to cause an affected device to reload. This vulnerability is due to improper handling of resources during an exceptional situation. An attacker could exploit this vulnerability by continuously connecting to an affected device and sending specific SSH requests. A successful exploit could allow the attacker to cause the affected device to reload. |
| A vulnerability in the Internet Key Exchange version 2 (IKEv2) function of Cisco IOS XR Software could allow an unauthenticated, remote attacker to prevent an affected device from processing any control plane UDP packets.
This vulnerability is due to improper handling of malformed IKEv2 packets. An attacker could exploit this vulnerability by sending malformed IKEv2 packets to an affected device. A successful exploit could allow the attacker to prevent the affected device from processing any control plane UDP packets, resulting in a denial of service (DoS) condition.
Cisco has released software updates that address this vulnerability. There are no workarounds that address this vulnerability. |
