| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A potential denial-of-service issue in the Proxygen handling of invalid HTTP2 priority settings (specifically a circular dependency). This affects Proxygen prior to v2018.12.31.00. |
| The Mojolicious module before 9.11 for Perl has a bug in format detection that can potentially be exploited for denial of service. |
| In libtirpc before 1.3.3rc1, remote attackers could exhaust the file descriptors of a process that uses libtirpc because idle TCP connections are mishandled. This can, in turn, lead to an svc_run infinite loop without accepting new connections. |
| Uncontrolled resource consumption in the Linux kernel drivers for Intel(R) SGX may allow an authenticated user to potentially enable denial of service via local access. |
| Improper access control in the firmware for some Intel(R) Processors may allow a privileged user to potentially enable a denial of service via local access. |
| ntpd in ntp before 4.2.8p14 and 4.3.x before 4.3.100 allows an off-path attacker to block unauthenticated synchronization via a server mode packet with a spoofed source IP address, because transmissions are rescheduled even when a packet lacks a valid origin timestamp. |
| A security vulnerability has been identified in all supported versions
of OpenSSL related to the verification of X.509 certificate chains
that include policy constraints. Attackers may be able to exploit this
vulnerability by creating a malicious certificate chain that triggers
exponential use of computational resources, leading to a denial-of-service
(DoS) attack on affected systems.
Policy processing is disabled by default but can be enabled by passing
the `-policy' argument to the command line utilities or by calling the
`X509_VERIFY_PARAM_set1_policies()' function. |
| A maliciously crafted HTTP/2 stream could cause excessive CPU consumption in the HPACK decoder, sufficient to cause a denial of service from a small number of small requests. |
| A vulnerability named 'Non-Responsive Delegation Attack' (NRDelegation Attack) has been discovered in various DNS resolving software. The NRDelegation Attack works by having a malicious delegation with a considerable number of non responsive nameservers. The attack starts by querying a resolver for a record that relies on those unresponsive nameservers. The attack can cause a resolver to spend a lot of time/resources resolving records under a malicious delegation point where a considerable number of unresponsive NS records reside. It can trigger high CPU usage in some resolver implementations that continually look in the cache for resolved NS records in that delegation. This can lead to degraded performance and eventually denial of service in orchestrated attacks. Unbound does not suffer from high CPU usage, but resources are still needed for resolving the malicious delegation. Unbound will keep trying to resolve the record until hard limits are reached. Based on the nature of the attack and the replies, different limits could be reached. From version 1.16.3 on, Unbound introduces fixes for better performance when under load, by cutting opportunistic queries for nameserver discovery and DNSKEY prefetching and limiting the number of times a delegation point can issue a cache lookup for missing records. |
| A memory leak in the fsl_lpspi_probe() function in drivers/spi/spi-fsl-lpspi.c in the Linux kernel through 5.3.11 allows attackers to cause a denial of service (memory consumption) by triggering pm_runtime_get_sync() failures, aka CID-057b8945f78f. NOTE: third parties dispute the relevance of this because an attacker cannot realistically control these failures at probe time |
| The denial-of-service can be triggered by transmitting a carefully crafted CAN frame on the same CAN network as the vulnerable node. The frame must have a CAN ID matching an installed filter in the vulnerable node (this can easily be guessed based on CAN traffic analyses). The frame must contain the opposite RTR bit as what the filter installed in the vulnerable node contains (if the filter matches RTR frames, the frame must be a data frame or vice versa). |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmfmac: pcie: handle randbuf allocation failure
The kzalloc() in brcmf_pcie_download_fw_nvram() will return null
if the physical memory has run out. As a result, if we use
get_random_bytes() to generate random bytes in the randbuf, the
null pointer dereference bug will happen.
In order to prevent allocation failure, this patch adds a separate
function using buffer on kernel stack to generate random bytes in
the randbuf, which could prevent the kernel stack from overflow. |
| In the Linux kernel, the following vulnerability has been resolved:
net: fix removing a namespace with conflicting altnames
Mark reports a BUG() when a net namespace is removed.
kernel BUG at net/core/dev.c:11520!
Physical interfaces moved outside of init_net get "refunded"
to init_net when that namespace disappears. The main interface
name may get overwritten in the process if it would have
conflicted. We need to also discard all conflicting altnames.
Recent fixes addressed ensuring that altnames get moved
with the main interface, which surfaced this problem. |
| In the Linux kernel, the following vulnerability has been resolved:
net: dsa: felix: Fix memory leak in felix_setup_mmio_filtering
Avoid a memory leak if there is not a CPU port defined.
Addresses-Coverity-ID: 1492897 ("Resource leak")
Addresses-Coverity-ID: 1492899 ("Resource leak") |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/bnxt_re: Avoid CPU lockups due fifo occupancy check loop
Driver waits indefinitely for the fifo occupancy to go below a threshold
as soon as the pacing interrupt is received. This can cause soft lockup on
one of the processors, if the rate of DB is very high.
Add a loop count for FPGA and exit the __wait_for_fifo_occupancy_below_th
if the loop is taking more time. Pacing will be continuing until the
occupancy is below the threshold. This is ensured by the checks in
bnxt_re_pacing_timer_exp and further scheduling the work for pacing based
on the fifo occupancy. |
| In the Linux kernel, the following vulnerability has been resolved:
mm/hugetlb: fix memfd_pin_folios free_huge_pages leak
memfd_pin_folios followed by unpin_folios fails to restore free_huge_pages
if the pages were not already faulted in, because the folio refcount for
pages created by memfd_alloc_folio never goes to 0. memfd_pin_folios
needs another folio_put to undo the folio_try_get below:
memfd_alloc_folio()
alloc_hugetlb_folio_nodemask()
dequeue_hugetlb_folio_nodemask()
dequeue_hugetlb_folio_node_exact()
folio_ref_unfreeze(folio, 1); ; adds 1 refcount
folio_try_get() ; adds 1 refcount
hugetlb_add_to_page_cache() ; adds 512 refcount (on x86)
With the fix, after memfd_pin_folios + unpin_folios, the refcount for the
(unfaulted) page is 512, which is correct, as the refcount for a faulted
unpinned page is 513. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/panthor: Restrict high priorities on group_create
We were allowing any users to create a high priority group without any
permission checks. As a result, this was allowing possible denial of
service.
We now only allow the DRM master or users with the CAP_SYS_NICE
capability to set higher priorities than PANTHOR_GROUP_PRIORITY_MEDIUM.
As the sole user of that uAPI lives in Mesa and hardcode a value of
MEDIUM [1], this should be safe to do.
Additionally, as those checks are performed at the ioctl level,
panthor_group_create now only check for priority level validity.
[1]https://gitlab.freedesktop.org/mesa/mesa/-/blob/f390835074bdf162a63deb0311d1a6de527f9f89/src/gallium/drivers/panfrost/pan_csf.c#L1038 |
| In the Linux kernel, the following vulnerability has been resolved:
clk: bcm: dvp: Assign ->num before accessing ->hws
Commit f316cdff8d67 ("clk: Annotate struct clk_hw_onecell_data with
__counted_by") annotated the hws member of 'struct clk_hw_onecell_data'
with __counted_by, which informs the bounds sanitizer about the number
of elements in hws, so that it can warn when hws is accessed out of
bounds. As noted in that change, the __counted_by member must be
initialized with the number of elements before the first array access
happens, otherwise there will be a warning from each access prior to the
initialization because the number of elements is zero. This occurs in
clk_dvp_probe() due to ->num being assigned after ->hws has been
accessed:
UBSAN: array-index-out-of-bounds in drivers/clk/bcm/clk-bcm2711-dvp.c:59:2
index 0 is out of range for type 'struct clk_hw *[] __counted_by(num)' (aka 'struct clk_hw *[]')
Move the ->num initialization to before the first access of ->hws, which
clears up the warning. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: carl9170: re-fix fortified-memset warning
The carl9170_tx_release() function sometimes triggers a fortified-memset
warning in my randconfig builds:
In file included from include/linux/string.h:254,
from drivers/net/wireless/ath/carl9170/tx.c:40:
In function 'fortify_memset_chk',
inlined from 'carl9170_tx_release' at drivers/net/wireless/ath/carl9170/tx.c:283:2,
inlined from 'kref_put' at include/linux/kref.h:65:3,
inlined from 'carl9170_tx_put_skb' at drivers/net/wireless/ath/carl9170/tx.c:342:9:
include/linux/fortify-string.h:493:25: error: call to '__write_overflow_field' declared with attribute warning: detected write beyond size of field (1st parameter); maybe use struct_group()? [-Werror=attribute-warning]
493 | __write_overflow_field(p_size_field, size);
Kees previously tried to avoid this by using memset_after(), but it seems
this does not fully address the problem. I noticed that the memset_after()
here is done on a different part of the union (status) than the original
cast was from (rate_driver_data), which may confuse the compiler.
Unfortunately, the memset_after() trick does not work on driver_rates[]
because that is part of an anonymous struct, and I could not get
struct_group() to do this either. Using two separate memset() calls
on the two members does address the warning though. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/hns: Modify the print level of CQE error
Too much print may lead to a panic in kernel. Change ibdev_err() to
ibdev_err_ratelimited(), and change the printing level of cqe dump
to debug level. |
